Ameba DigiCap II series Manuel d'utilisateur télécharger pdf (Page 9)

3-3 Install the Central Processing Unit (CPU)

3-3.1 Installing the CPU

The DVR’s board comes with a surface mount Socket 775 (LGA775) design for Intel Pentium 4

Processor in the 755-land package.

Fig. 3-3.1 Fig. 3-3.2

Fig. 3-3.3 Fig. 3-3.4 Fig. 3-3.5

Follow these steps to install a CPU

1. Locate the CPU socket on the platform. (Fig. 3-3.1).

2. Press the load lever with your thumb (A) and remove it to the left (B) until it is released from the

retention tab. (Fig. 3-3.2)

3. Lift the load lever in the direction of arrow to a 135-degree angle. (Fig. 3-3.3)

4. Lift the load plate with your thumb and forefinger to a 100 degree angle (A), then push the PnP cap

from the load plate window to remove (B). (Fig. 3-3.4)

5. Position the CPU over the socket, making sure that the gold triangle is on the bottom-left corner of

the socket. The socket alignment key should fit into the CPU notch. (Fig. 3-3.5)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 117 118

Pas de commentaire

Ameba DigiCap II series Manuel d'utilisateur Page 9