Ameba DigiCap II series Manuel d'utilisateur télécharger pdf (Page 48)

Fig 6-3.5 Fig 6-3.6

If you happen to be using a Speed Dome camera, you can also adjust P (Preset positions) and S

(Speed of Motor). Note that pressing “A” when modifying a Speed Dome camera will give

different options more than if you were using a P/T/Z. Click on “P” to set preset positions.

Adjust the camera to where you want it to view, and then press “Set”. You can add as many as

there is room. If you want to test settings by moving the camera to the preset position, just

press “Goto” and it will move to the position you set it to. (Refer Fig.6-3.7)

Pressing “S” on the menu bar will allow you to set the speed for this camera’s pan, tilt, and zoom.

Just slide the bar to your desired speed. The above functions are for Speed Dome camera only.

Pressing “S” on the menu bar will allow you to set the speed for this camera’s pan, tilt, and zoom.

Just slide the bar to your desired speed (Refer Fig.6-3.8). The above functions are for Speed

Dome camera only.

Fig. 6-3.7 Fig. 6-3.8

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 117 118

Pas de commentaire

Ameba DigiCap II series Manuel d'utilisateur Page 48