Ameba DigiCap II series Manuel d'utilisateur télécharger pdf (Page 11)

3-4. Install Memory module

The Platform comes with Double Data Rate (DDR) Dual Inline Memory Module (DIMM) socket.

These sockets support up to 2GB system memory using 184-pin unbuffered non-ECC

PC3200/PC2700/PC2100 DDR DIMMs.

For optimum capability, it is recommended that you obtain memory modules from the same

vendor.

The following figure shows the location of DDR DIMM sockets and steps to install a DIMM.

1. Unlock a DIMM socket by pressing the retaining clips outward.

2. Align a DIMM on the socket such that the notch on the DIMM matches the break on the socket.

3. Firmly insert the DIMM into socket until the retaining clips snap back in place and the DIMM is

properly seated.

Make sure to unplug the power supply before adding or moving DIMMs or other system

components. Failure to do so may cause severe damage to both the platform and the

components.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 117 118

Pas de commentaire

Ameba DigiCap II series Manuel d'utilisateur Page 11